On the keypad press and hold the Program button until the LED changes from green to red. Press the number for the door you are programming, 2 or 3. On the keypad enter the new PIN number and press the Up/Down button. * repeat steps 1-4 for each door opener to be 5. On the key pad press the number of garage doors to be programmed 2 or 3 4.
On the wireless keypad enter a new PIN (3-8 digits) and different than the PIN for other Garage Doors programmed to this keypad. Programming Keypad for Multiple Garage Doors 1. Note: The key pad will be active while the keypad backlight is on (about 30 seconds) and pressing any button on the keypad will cause the door to open or close during this 30 seconds that the backlight on Press the Up/Down button on the keypad a third time and the garage door should open. Press the Up/Down button on the keypad a second time and the LED on the opener should go 6. Press the Up/Down button on the keypad once. On the wireless keypad, enter the new 3-8 digit Pin you entered in the keypad set up mode. Press and release this button and the LED will start flashing.
REPROGRAMMING GENI INSTACODE KEYPAD GARAGE OPENER CODE
Older Genie openers will have a Learn Code button. (The round LED should turn blue and then go off, then the long LED should flash purple. Press and hold the Program/Set button for about 2 seconds. They could be on the bottom side of the opener motor or behind the lens cover on older model Genie’s. Programming your Genie Garage Door opener to the new Keypad First you will need to locate the program buttons and LED lights on the Genie Garage Door Opener. Your single garage door is now ready for programming. On the keypad enter your new PIN (3-8 numbers long). The keypad is now set for all Genie model garage door openers. Release the program key and allow the lights on the keypad to go out. Press and hold the program key until the LED light changes from green to red. The keypad light should go to a solid lighted condition. On the keypad press 3-5-7 and then press the up/down key. This procedure is for programming a single garage door to the keypad.
You will first need to prepare the wireless keypad to work with any Genie Intellicode opener. The following procedures will walk you through the programming process. The Genie Model GK-BX (aka: GKCA-BX, GKCG-BX, GKCT-BX) wireless keypad can be programmed to work with 1-3 different garage doors.
0 kommentar(er)
